Energizer 515 Uživatelská příručka stáhnout pdf (Strana 29)

12 Chapter: 2

Install battery

Medtronic MiniMed designed the pump to only accept a NEW battery. As a safety measure, if you

install a battery that does not have full power, the “weak battery” or “failed batt test” alarms may

sound. If a “weak battery” alarm happens, respond to the alarm and continue. The pump will still

operate normally, but with a decreased battery life. The pump uses one AAA alkaline battery.

1 Make sure all the following apply:

➠ Clear (ESC, ACT) any alarms and/or alerts before removing and replacing the battery

➠ Make sure the pump is at the HOME (idle) screen when you remove the battery.

➠ Do NOT remove the battery during a bolus or prime delivery.

2 Use the edge of a coin to remove the battery cap. Turn the cap in a counter-clockwise direction.

3 Remove the old battery and dispose of it per the

disposable requirements of your state or country. Put

the new battery in the pump with the negative end

[(-) symbol] going in first. Check the label on the back

of the pump to make sure the battery is inserted

correctly.

NOTE -

Do not use batteries that have been in cold storage (i.e., in the refrigerator or your car in

the winter).

4 Place the battery cap in the pump and tighten so the slot is

aligned horizontally with the pump as shown here:

Do NOT apply force when you turn the cap.

CAUTION: Do not use a rechargeable or carbon zinc battery in your pump. For best

results, a new AAA Energizer alkaline battery is recommended.

CAUTION: Do NOT over-tighten the battery cap.

You should not turn the cap more than

four half turns. If you over-tighten the

cap you may not be able to remove it,

and you can damage your pump.

ESC

Battery cap

one half-turn

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 183 184

Žádné komentáře

Energizer 515 Uživatelská příručka Strana 29